Rad Wagon w/ Bolton Controller making all kinds of weird sounds! 😫

[Andrewinoc]

Hey all, first post here. Installed the 35a controller kit with color display last night on my 2019 wagon (with only 2 bolts and some zip ties). Did the recommended programming but getting some really loud whirring and troubling noise from the motor.

Anyone have insight? I searched through the forum but could not find any results.

 

[AHicks]

If this is a Bolton kit, I have to assume the motor is wired correctly as it should have been plug and play (assuming it's plugged in completely). That leaves the set up parameters as the potential source of your evils. Does he supply suggested settings? If so, have you been through the setup parameters to confirm they are ALL correct?

 

[Andrewinoc]

Hi and thanks. I used his stock setup but it's for Rover. Found a wagon program that's slightly different for direct drive motor but to no avail.

 

[AHicks]

I know there's a bunch, but maybe take a minute to jot down ALL of your parameters and I'll go through them. MUCH easier than going back and forth playing guessing game.