Is it possble to covert 26x4 to 3 onch tire and rim combo

[PCeBiker]

0, 00, 000 are the wire gauge increments, that last one is sometimes called a fatty.

Well that makes sense.

What's bigger than nothing? Two nothings.

Three nothings is even bigger !!

I wonder what gauge this wire would be??
That's A Lot of nothing.
Maybe even too much nothing to measure ??

Here's the link to the nipple sizes, half way down the page. Maybe it is just moped category that it applies.

Yeah, I don't know what's going on?

And I don't trust myself to try and take measurements with an accuracy of less than a mm.



I wanted to put a new barrel plug on battery charger because the connector was getting sloppy, but I couldn't figure out what size pin was on my battery's charge port,..

I ended up buying this adapter to use the end that fit,..

Both ends of adapter cord worked??

I just used the end that felt tighter.

I sure couldn't tell for lookin.

 

[RunForTheHills]

00 is pronounced double aught and 000 is triple aught.

 

[PCeBiker]

00 is pronounced double aught and 000 is triple aught.

I found out that there's 0000 available as well,..

I think that I'll buy me some me some quad aught wire for my ebike?


AI search says that the 36" Golden Gate Bridge cables would have a AWG number of about -1

Choosing a logarithmic scale to measure wire diameter is stupid.

If they simply counted up as the wire got thicker, it would be a linear scale that counts in a straight line.


I'm just used to it, but still irritates me.

 

[kevinmccune]

I kinda gave up on the project as well. I'm just going to use my old front rim if I do anything.
From what I understand, "made in Taiwan" is a good thing, it's not the same as "made in China"




I'm not sure about that?
I "measured" my spoke nipples with my spoke wrench,..


View attachment 212173


My front wheel has 13 gauge nipples. 14 wouldn't fit, and 12 was too loose.

So I guess that I'd need to measure my spoke diameter to find out if the nipples are drilled and tapped for 13 or 14 gauge spokes?
(if that is how it works?)


I've got this spoke measuring tool as well,..


View attachment 212174numeral


It looks like it's mm instead of the gauge measurements??

(The "gauge" system is stupid anyway. A fatter spoke should be a larger gauge number. Wire gauge is just as stupid. A Big Fat wire is "0" gauge. What would an even fatter wire measure? Does it go into negatives or fractions after Zero Gauge?)

it adds numerals to the "ought",1/0.2/0 etc

 

[PCeBiker]

it adds numerals to the "ought",1/0.2/0 etc

Ohh OK.
So there are some numerals involved.

I thought it was just an endless string of zeros until you finally reach absolute zero, then it starts going towards a negative value.

(It's still a stupid way to count though. )

 

[kevinmccune]

Ohh OK.
So there are some numerals involved.

I thought it was just an endless string of zeros until you finally reach absolute zero, then it starts going towards a negative value.

(It's still a stupid way to count though. )

agree,know what some say is on the other side of absolute zero? absolute heat( I don't believe it,however the little egg sitting there ,KABOOM! you never know.