Bxg
Active Member
Yes, even a little less. I cut something like 13 inches, then split that in half longwise. Then trimmed one edge a little so as not to cover the pin stripe thing. Then cut another 10 inches or so and split off 1 inch strips for the fork logos. I still have enough that i might put some down the back tube to even things out.Thanks i looked it up on amazon. They recomend heat to remove. Then solvent for leftover glue. It says tape is 5 inches wide. Is 2 1/2 inces enough to cover height of the lectric branding?
I wish I could've cut it into letters and covered the LECTRIC logo exactly. Then when it reflects, it would glow the lectric logo in the dark.