Hydraulic Brake Troubles

[PedalUma]

There is a little Philips screw facing out to the side. That is the spring tension adjustment. On the side that is not moving, screw it in all the way then start backing it out as you squeeze the brake lever. If this does not do it then you need to remove the five millimeter bold at the front of that side and grease the smooth shaft and brass washers.

 

[rccarguy]

There is a little Philips screw facing out to the side. That is the spring tension adjustment. On the side that is not moving, screw it in all the way then start backing it out as you squeeze the brake lever. If this does not do it then you need to remove the five millimeter bold at the front of that side and grease the shaft and brass washers.

Don't screw it all the way in you'll put a lot of strain on a the spring

 

[Cowlitz]

Cancel the other post. Just rode 3 miles and the rear brake was bad again.

With my track record, I am not going to attempt to "fix" it myself.