Archon X1 Programming Thread (questions and experiences)

[TPEHAK]

The new generation of the INNOTRACE controller is coming!

 

[TPEHAK]

The next generation VESC based INNOTRACE motor controller works!

 

[bindi]

I played around a little bit and was finally able to connect via VESC Tool to my Innotrace X1!

Can this be used to fine-tune thumb throttle sensitivity? ("start", "end", in millivolts - like on BBSHD) I'm about to do an Innotrace build, and I've tested my friends one - his thumb throttle has wayyyy too much deadzone..

How about field weakening, I think I heard somewhere that there is very little field weakening applied on the Innotrace. Can it be tweaked further?

edit: from earlier post, the field weakening tab is empty??? XD what is this

View attachment 198932