Trouble opening a motor

[scouter]

Hello everyone!

I own some really old Daymak Vienna prototype and i damaged a hall sensor when changing the tires.
<- motor tester, the 3 lights are supposed to blink in series

I'm trying to open the cover of the motor to replace the hall sensor board but its really really firmly stuck! do i need a special tool to open it?
Is there a secret technique? Because both motor cover can "spin" in place but i can't pull it after removing all screws
<- Motor cover cable side
Its special (ac 60V 250W) and really expensive

Ask me any info about my scooter, i hope you all can help me

 

[rich c]

A scooter site probably has people who have split that motor.

 

[scouter]

A scooter site probably has people who have split that motor.

well i looked around a lot and i couldn't find a guide or anything on how to open a daymak hub motor
there are electric scooter forums?

 

[PedalUma]

It should be just a matter of removing the screws and pushing down.

 

[scouter]

Scrap it is my helpful advice and buy a new ebike.

My ebike is working right now, i just placed different motor i found on it while i'm repairing this one.

It should be just a matter of removing the screws and pushing down.

pushing?! i didn't think about that, i'll try it.

 

[PedalUma]

pushing?

Put down some cardboard, grabbing the outer tire and push and tap down. The motor will side up and out of the housing.

 

[scouter]

Put down some cardboard, grabbing the outer tire and push and tap down. The motor will side up and out of the housing.

HEY it worked!! (if by push you meant violently slam) thank you! i'll change that little pcb now

 

[PedalUma]

That is great!!! Another EBR success.