Clean Custom Conversions

A young teen and his grandmother purchased a single speed Schwinn coaster brake used bike in new condition at a church sale for $70. They do not have much money and wanted a simple low cost conversion. I just did this. And, yes the time stamp is off.
nice,one question ,I have used the small hangy hailong 10 ah 48 volts batteries to good effect,seems like one of those would have worked in front of the controller bag,have you used these?
A young teen and his grandmother purchased a single speed Schwinn coaster brake used bike in new condition at a church sale for $70. They do not have much money and wanted a simple low cost conversion. I just did this. And, yes the time stamp is off.
 
Anyone have any interesting builds they are planning or working on?
I do have a question,I have just acquired a full suspension( maybe a bit over powered compared to my old favorite 500 FS 26" mag wheel bike) 27.5" mtb style bike,its a bit cramped and I like "Dutch style bikes,how can I fix it,due to my back I like upright cruised style,I want to extend and replace HB with a dutch style and its a bit low as well any suggestions?
 
I do have a question,I have just acquired a full suspension( maybe a bit over powered compared to my old favorite 500 FS 26" mag wheel bike) 27.5" mtb style bike,its a bit cramped and I like "Dutch style bikes,how can I fix it,due to my back I like upright cruised style,I want to extend and replace HB with a dutch style and its a bit low as well any suggestions?
Sure. Get an adjustable riser stem and a moustache bar. You will need to cut about 3/4 of an inch off each end of the bar.
 
Sure. Get an adjustable riser stem and a moustache bar. You will need to cut about 3/4 of an inch off each end of the bar.
ok,one question though,can a riser be acquired that moves the handle bar forward,the wheelbase was shorter then I liked even though I am close to 6.2 my inseam is rather short.
 
Here is one adjustable stem riser that comes in different lengths.
1795272976124.png


And here is a bar. It is too wide but can be trimmed. I use a pipe cutter. It also has a rise.

1795273192085.png
 
Back