Can Lectric's ONE be converted to kt-lcd3?

[Tom521]

The Lectric ONE is much like a lot of ebikes: the throttle is more like a light switch than a throttle.

I've tried adjusting the settings in the PAS and other areas that could possibly affect the smoothness of the throttle - particularly when starting off from a stop or trying to hold a steady part-throttle speed - without much success.

In searching the internet there are lots of claims about overcoming the smoothness problem by using a KT-LCD3 controller and display. For example there's one on Amazon here:

https://www.amazon.com/Waterproof-Electric-Controller-Throttle-Conversion/dp/B0DK5T23F7

So my question is this: can I use this (or something similar) on my Lectric ONE?

Thanks for any experience!

Tom

 

[RunForTheHills]

Yes, but you may need to solder connectors and it would be good to have a multimeter for the project.

 

[harryS]

$149? THey should throw in the PAS sensor so you know you have one that will work.

 

[Tom521]

RunForTheHill,

Does "Yes" mean that it will work on this particular ebike to correct the "light switch" throttle action and make it gradual?

Soldering and using a multimeter is no problem. I'd need concise instructions concerning what wire goes where.

Is there a spot on the 'net that shares those details?

Tom