ST1 X - Torque value to tighten torque sensor ?

[Salade]

Hi,

Do you know the torque value to tighten the torque sensor screws (A,B and C) shows on attached image ?
I bought a torque wrench and I noticed that the rear wheel was initialy tightened more than 30 Nm while the value is 20 Nm.

Regards

 

[smitty]

Component ST2S ST2 Torque

Clamping handles (Ergon GS1-L) – handlebar * * 5 Nm

Clamping brake lever (Tektro) – handlebar - * 5 – 7 Nm

Clamping brake lever (Magura) – handlebar * * 4 Nm

Clamping gear lever (Shimano SLX) – handlebar - * 3 Nm

Clamping gear lever (Shimano Alfine Di2) – handlebar * - 5 – 7 Nm

Clamping stem - handlebar * * 6 Nm

Clamping stem – steer tube (carbon) * * 5 Nm

Clamping headset top cap – steer tube * * 3 Nm

Clamping saddle underframe * * 13 – 15 Nm

Clamping saddle angle * * 10 – 12 Nm

Clamping saddle clamp – frame – saddle post * * 10 Nm

Front axle * * 20 Nm

Rear axle * * 20 Nm

Brake disk (6-hole, Tektro) - * 6 – 8 Nm

Brake disk (6-hole, Magura) * * 4 Nm

Brake disk (4-hole, Syno Drive HR-Hub) * * 7 Nm

Bottom bracket, FSA MegaExo * - 40 – 50 Nm

 

[Salade]

Hi Smitty,
Thank you for the answer.
I was aware of these values but the screws A,B and C are not in this list (according to me)
Regards