PIM Brakes

[GOLDBARBILL]

I have a PIM Polaris fat tyre ebike. It came with Magura cable disk brakes. I would like to convert to hydraulic brakes and figure Magura would be the logical choice. Has anybody done this and where did you get your components? Bill Gold Bar, WA

 

[fooferdoggie]

so does it have motor cutoffs on the brake levers? if not then you can choose any brake you want. Had magura mt4's and they were powerful but they took too much work for me to use 1 fingered so I went with the Shimano 4 piston. but those take more fines as they are so easy and grabby. the magma pads lasted far longer then the Shimano pads.

 

[GOLDBARBILL]

I am going to need something with motor cutoffs or try to fabricate.

 

[fooferdoggie]

I am going to need something with motor cutoffs or try to fabricate.

ya that eliminates a lot if you want it pre made then you need to know if yours are a normally closed or open type. the maurga e bike levers have a wire most likely normally open since its for a brake light. these might work https://em3ev.com/shop/shimano-m355-hydraulic-brake-levers-ebrake-sensor/