Glad to find this forum

[jmouca]

My nick jmouca and new to be here. Home in Czech Rep. Owning one old e-bike TranzX Eagle and even old e-scooter Nitro restored with hub motor instead former chain drive. Next time prepare photos to attach.
Wishing lucky rides, jmouca.

 

[indianajo]

Welcome to the site. Sounds like you have been in the hobby for some time.

 

[jmouca]

Sure, sometimes need help, not all is to know from internet sellers, because they are sellers, not electricians. Bought new sine wave controller and cannot find there output for on-off. On this forum was tabelle off outputs an now motor move to run. Big help, thanks forum.

 

[indianajo]

On some of my controllers the enable switch was labeled "door switch". It has to be connected to a battery plus input for the motor to move. I use the red wire on the alarm power connector, which is always hot, to feed a toggle switch shielded from rain in a pill bottle. Funny name; bicycles do not have doors.

 

[Stefan Mikes]

Czech Republic! A lovely montane country full of good production e-bikes!

Horní Malá Úpa. The highest village in the Czech Republic, and it even has a craft brewery!

Borderland between Czech Republic and formerly Germany now Poland.

Beautiful villages (Broumovsko).

Hejnice in Jizerske Hory. After a 12 km and 500 m elevation loss downhill ride on switchbacks

 

[JGcycle]

Welcome to the forum.

 

[Tbagwell]

Welcome on board

 

[jmouca]

Welcome to the site. Sounds like you have been in the hobby for some time.

Yes, this my bike Eagle produced TranzX by 40 years anyversary, when lunar module Eagle landed on the Moon. Its a little design bike with only 250W motor, max. 25 kmh. Improved with 8Hz generator for simulate PAS. Switchable on/off.
Today compleated sine-wave controller change on my small scooter and test ride. Wonderfull smooth and silent start. Only remaint to do a limit (25kmh), otherwise can be too fast 50kmh, here not alowed.