PAS is cutting out intermittently while the throttle still works. I've visually checked all connections. Cutoff occurs for a couple of seconds every few minutes.
I think all Ecotrics use the integrated sensor, but you can look to see if it uses the separate magnet disk, and that the sensor didn't get jarred.
Then open up the place where they put your controller and check the connector from the PAS sensor. It's a plastic box on the Hammer? The connector might have gotten wet.
EDIT: I see you done the above.
If that's not it, the fix is either a new sensor or replace the controller. Ecotric customer service likes to see videos. That's going to be tough to show them.
Thanks Harry, I blew compressed air over the ring magnet and that resolved the issue. I ride a lot on dirt and I think some debris got stuck between the ring magnet and sensor.