Dead as a doornail with fully charged battery

usclassic

Well-Known Member
Region
USA
My son dropped off the Aipas M1 Pro I gave him now dead. Battery checked and fully charged. Bent battery connections on bike per Aipas dead bike video. Also rear brake cable is sized which is the secondary issue. Absolutely nothing visible happens when the power button is pushed. So the fun has begun. lol
 
It has a display similar to this? Try reseating the connector. Might be loose.
Capture_2026-10-19_234011_4759564_f319f190f6f6484c97924d0fa8c24d7e.png

Aipas uses the 5 pin connector common to other bike displays, but appears to use their own wiring order.


Check pins 1 and 3 for battery power. If it is there, and display won't turn on, the display is likely at fault.
Capture_2026-10-19_235438_7878331_b8133831a15b4adb84503171f0ffbfdb.png
 
The few times that I experienced that problem it was always either:
  • Bad electrical connection between the battery and motor. (especially with Anderson connectors)
  • Bad display.
 
From Aipas support


I did it and the battery connection is tight. A warning though even with the battery removed sparks flew from those connectors when accidentally shorted so there must be charged capacitors in the controller..beware. I was surprised.

i did find a beetle living in here.....

PA201859.JPG


PA201860.JPG


Unplugged and reconnected the display still no joy. I do suspect the display and will try to get a new one to try.
 
From Aipas support


I did it and the battery connection is tight. A warning though even with the battery removed sparks flew from those connectors when accidentally shorted so there must be charged capacitors in the controller..beware. I was surprised.

i did find a beetle living in here.....

View attachment 216745

View attachment 216746

Unplugged and reconnected the display still no joy. I do suspect the display and will try to get a new one to try.


There are definitely charged capacitors in a controller! I shorted a power wire coming out of the motor last week while replacing a burnt Anderson connectors. Thought I fried my controller! But did not.
 
Back