Archon X1 Programming Thread (questions and experiences)

Any ideas why my original Innotrace X1 throttle works only for the first time? if I go full throttle, and let go, I can not use the throttle again (any speed), for a while. The first time it feels good and logical and smooth, after that, dead for a bit.
- tried two displays
- tried two throttles (known-good from my BBSHD)
- did encoder calibration with the X1tool
- (happens on the road too with proper load)

Video:
 
Does it also do it if you dont open the throttle all the way?
I think it works "okay" if I only actuate between 0-25% ish.

When the throttle dies, I can keep holding it at full throttle for 15 seconds and nothing happens, until I let go and there's a reaaally small slight nudge (in the motor).

EDIT: Also, the "hidden" unlocked sports mode also doesn't seem to work (with the small display); it always starts with throttle enabled and full power.

Sidenote: this Innotrace is second-hand, I bought it used, driven 2300km. But new to me and I just finished my build. Works okay with PAS only.

edit n^5: disabled "Safe Start" with VESC Tool and it works as expected now (i think at least!), wondering if there are any side effects ":)"

edit n^5+1: back to enabled "Safe Start", root cause was my BMS having Charge FETs disabled --> back EMF voltage spikes had nowhere to go --> controller spazzed out. (VESC tool showed 2026-11-16 01:27:30: Status: FAULT_CODE_OVER_VOLTAGE)
 
Last edited:
Now that the throttle is working fine, I have two other problems:

- Hidden sport mode (by special command with the small display) is non-existent, bike starts with throttle enabled. It should be by default in all units, or am I mistaken?

- Gear shift sensor inoperational, pinout seems correct but haven't inspected further. Might it not exists in my firmware at all?
 
If you mean by sport mode the unlimited speed off-road mode you need activate it each time you turn the display on by pressing the buttons Down and Mode simultaneously for 2 seconds after starting the display within 10 seconds after turning the display on (if the display shows logo on start then wait until the menu will be loaded after the logo and then press the Down and Mode buttons).

You can ask Krasnodar from Ex-Force.de if the X1 controller has shift sensor functional. And also ask him meanwhile when he will make that server for X1Tool up and running he promised us to launch "soon" many years ago.

You also need a battery that can supply the amperage and power this controller demands.
 
Last edited:
Back