Latest activity
-
spokewrench replied to the thread Failed cadence sensor.Yes, the sensor sends pulses to the controller connector. But if the sensor happened to have a magnet close to the transistor when the... -
I'm almost positive that a KT controller is only looking for the pulse. The waveform shown in the manual is a square wave. The...
-
What about buying a new P14L on eBay...
-
spokewrench replied to the thread Do you file depth gauges on safety chain?.I didn't like files. They would get dull. I'd have to set things up so I could apply pressure, and it was too easy to rock. I came to...
-
-
Gionnirocket replied to the thread Failed cadence sensor.I use a condom and see if it'll inflate like a balloon... Lubricated of course -
PedalUma replied to the thread Failed cadence sensor.Plumber's O-ring silicone. It lasts in kitchen faucets for ten-years. Nothing sticks to it. See the chicks with videos promoting women... -
-
I found out from @PedalUma that a valve core doesn't necessarily seal shut. It can also get jammed open an create a slow leak. I was...
-
RunForTheHills replied to the thread Failed cadence sensor.What about buying a new P14L on eBay... -
PedalUma replied to the thread How Often And How Long Are Class 3 E-Bikes Traveling At More Than 20 MPH?.Several years ago the Dick's Sporting Goods chain wanted women to advance into management positions from doing things like bike...
-
-
spokewrench replied to the thread Failed cadence sensor.I assume the pulses must pass through a capacitor in the controller. The capacitor would pass each rising and each falling pulse edge as...
-
Gionnirocket replied to the thread Failed cadence sensor.You're probably not using enough silicone grease 🙃 Or maybe your valve core is loose 🙃🙃 Fun fact: You know I put silicone grease on my...
-
-
Jeremy McCreary replied to the thread Watching the peloton - Professional Road Racing thread 2026.Watching Peacock's Stage 5 post-race coverage now. 1. Roll and CVV both giving Boudin a 50-50 chance to keep the jersey tomorrow. 2... -
spokewrench reacted to Marcela's post in the thread Do you file depth gauges on safety chain? with
Like.
I use an Oregon bench grinder. Have to make sure it is centered when cutting the knives or they cut crooked. Cut the gauges however... -
Rodents already eat PEX. That's one of the reasons we went with copper. -
spokewrench replied to the thread Failed cadence sensor.By "missed shifts," I mean when I pushed the button to change PAS power, sometimes the controller and display wouldn't change. I used...
