Reention Dorado 48v 17.5AH - BMS Help needed

[PCeBiker]

,.. Do you have any links to info on this as regards the motor 9pin (e.g. - the 3 Hall wires sequence), and how to recognise which "display" wires are which (for the 8pin)? I am obviously ok with the "power" orientation, and even the PAS.

Here's the thread that I started with.

My ebike is an ET.CYCLE T1000, and the company is owned by NCM, so it has Das-Kit components

Alternative Display and Controller for NCM (DAS-KIT)

Wanting to increase the PAS Max speed on my NCM bike I be quite satisfied with around 30-35kmh it currently 25kmh The Das-Kit system appears to be complete locked down so I'm considering if Sourcing a alternate KT display and controller that would plug and play with the current hub motor...

forums.electricbikereview.com

 

[PCeBiker]

Do you have any links to info on this as regards the motor 9pin

Splice motor cable to controller.

I have a Juiced RCS with damaged cable from the controller to the motor. The bike would work but the display would lose connectivity. I repaired the cable soldering some broken wires. The display started working again for 2 months and then quit again. I purchased a 20 inch extension cable with...

forums.electricbikereview.com

How do I select a correct replacement motor controller?

Possible anyone can identify this controller visually, or from the clues included with this post? There seems to be NO marking or indicators on the controller as to the make or manufacture or even critical details to assess compatibility with a suitable replacement. Where can I get direct...

forums.electricbikereview.com

Loud Noise on Acceleration in NEW Direct Drive Hub Motor (Video Included)

Can anyone help me diagnose this sound? It only happens when accelerating. Metallic sound, almost like grinding gears. However this is a 2000 W (new) direct drive motor which should be gearless. My current hypothesis is that my controller is square wave instead of sine. I was looking for a...

forums.electricbikereview.com

I bought a Grin Satiator equivalent for $77 CAD

It's a Mean Well 240 Watt 4.45 amp 54 Volt LED driver with adjustable voltage and current output. I need to set the levels manually. They are not programmable. (YAY !!) It turns out that it only has a 3.34 amp output with a standard 120 VAC North American outlet. I could wire it into my...

forums.electricbikereview.com

 

[PCeBiker]

I can see that you are more advanced than me when it comes to controller wiring mods!

I've taken apart and looked at every electric and electronic thing on both my ebikes, except for the BMS

I have everything that I need to plug into my BMS's to check and balance the cells manually, but I'm not gunna try to remove the cell pack from the aluminum case.

I'd really like to probe my batteries, but I'm trying to restrain myself.

They're all working fine now, and there's not need to tear them open.
But I still wanna.

Replace Battery, Controller, or Something Else?

Thanks. I tried searching for it, but I didn't know what to call it. It's kind of expensive though, and I don't really need it. I think that if it comes to it, I'll just charge up the individual cell groups directly at the BMS connector. I would only need my voltmeter and my bench power...

forums.electricbikereview.com