Hi, New here so not done much searching yet on this. Just purchased an Orbea Keram Max 20 (29er) with Bosch motor and setup below. When I received the bike it had almost full charge. Took it out on a 20 mile ride, few hills and along road and bridleway, some light puddles and dirt. When I got back display showed 1 bar left on battery. I switched off bike, lightly washed bike with warm water making sure I didn't put loads over motor and battery area, dried and then took battery out to charge. Battery charged for about 3 hours, top bar on battery was flashing when I took it off charge. I re-installed battery in bike (still had lubrication on contacts) and bike is dead. Doesn't power on, took battery out to try and reset, does nothing, no led lights, no response to reset sequence and won't charge. Bike is going back to dealer for diagnostics, can't see any dirt on contacts but don't want to take anything apart. Anyone experienced similar or same?
fletchja
fletchja
Battery (Wh): | 500Wh |
Motor: | BOSCH Performance CX Cruise |
User Interface: | BOSCH Performance Purion |