Good morning,
I have two zundapp z802 bikes, which, from what I have found out, have an Ananda MC5-B0 and a D13 display.
I have noticed in recent days that one of them significantly lowers the speed, previously the difference was up to 1 km/h, now it is up to 6-7 km/h.
I managed to enter the settings on the display and see that the wheel size is set to 20, where in fact it is 28, I wanted to change the setting, but after the reset it returns to the old value. I assume this is permanently disabled on the driver side.
I purchased an S866 display with communication protocol no. 2. however, it gives error E10.
In addition to setting the correct wheel size, I would also like to slightly change the support values to values 1-5.
Do you know a way to do this? Is there a programmer that will allow access to this controller?
I have two zundapp z802 bikes, which, from what I have found out, have an Ananda MC5-B0 and a D13 display.
I have noticed in recent days that one of them significantly lowers the speed, previously the difference was up to 1 km/h, now it is up to 6-7 km/h.
I managed to enter the settings on the display and see that the wheel size is set to 20, where in fact it is 28, I wanted to change the setting, but after the reset it returns to the old value. I assume this is permanently disabled on the driver side.
I purchased an S866 display with communication protocol no. 2. however, it gives error E10.
In addition to setting the correct wheel size, I would also like to slightly change the support values to values 1-5.
Do you know a way to do this? Is there a programmer that will allow access to this controller?
