Ben J
Well-Known Member
- Region
- USA
Well I would have said no, but on my new chain's maiden voyage I kind of accidentally did. I'm not sure the seals in the shock/fork care how deep the bumps you hit are as much as they care about how many cycles they do. The witness rings on mine are usually sitting around 60-70% travel so the shock gets some action.Are you riding technical singletracks?
The shock on the 6 is a RS-DLX-SELP-C1, max PSI is 360. You've got to do a lot of math to figure out PSI-to-weight on a shock since the leverage ratios vary depending on bike geometry (unlike the fork that is directly compressing). Rockshox has a calculator if you want to play with it. You'll need the model and the travel of the bike.You run the rear shock at over 300psi?
I ran it at about 400PSI, but I am losing weight so soon I might be inside factory specs. I rationalized it this way: The amount of air pressure internal to the shock that it takes to hold you up is going to be the same no matter how much air you put in. It will just change the sag. The true max pressure is when you bottom out the shock, which I never have. And if I blow out the seals, I can just rebuild it.