hellobritt
New Member
- Region
- USA
Hi all (new member here),
I have installed the Grin Advanced wheelbarrow kit and had a few questions someone that uses their phaserunner suite might be able to answer. The number of magnetic pole pairs for this hub is 237. However, I can't configure the CA with any number larger than 99 (only takes two characters). Additionally, I have the USB-TTL cable, and thought to write the correct information to the controller via the phaserunner software. However, the software is only able to see the port, but not connect to the controller. I've tried the software on both linux ubuntu and windows 10. I am able to read and write to the controller via the cycle analyst setup utility (however, that software limits the number of poles to <= 99).
I really need to adjust the regen braking so that when I let of the throttle, the hub maintains a certain speed or lower while going downhill with a heavy load. Does anyone have any ideas? Thank you
EDIT: I ran the linux appimage with regular permissions and sudo permissions with the same result...port recognized but controller not connected.
EDIT2: I am an idiot and finally realized I have to connect the USB-TTL cable directly to the controller jack.
I have installed the Grin Advanced wheelbarrow kit and had a few questions someone that uses their phaserunner suite might be able to answer. The number of magnetic pole pairs for this hub is 237. However, I can't configure the CA with any number larger than 99 (only takes two characters). Additionally, I have the USB-TTL cable, and thought to write the correct information to the controller via the phaserunner software. However, the software is only able to see the port, but not connect to the controller. I've tried the software on both linux ubuntu and windows 10. I am able to read and write to the controller via the cycle analyst setup utility (however, that software limits the number of poles to <= 99).
I really need to adjust the regen braking so that when I let of the throttle, the hub maintains a certain speed or lower while going downhill with a heavy load. Does anyone have any ideas? Thank you
EDIT: I ran the linux appimage with regular permissions and sudo permissions with the same result...port recognized but controller not connected.
EDIT2: I am an idiot and finally realized I have to connect the USB-TTL cable directly to the controller jack.
Last edited: