draver
Active Member
I've been doing some research to find the proper size common glass screen protector for our 2 Lectric XP's with Nakto displays. Amazon has a great selection, but unfortunately most listings do not give the exact dimensions of the actual item. A few days ago I even went to Best Buy with the measurements and checked their cameras on display for the LCD sizes for cross reference. A few were close, but not exactly what I wanted. I finally did find one and was able to confirm it's measurements by asking a question and receiving a prompt reply. The ones I purchased and installed are:
Amazon.com : PCTC Tempered Glass Screen Protectors Film Compatible for Fujifilm Fuji X-T200 XT200 X-A7 XA7 Protective Cover (3 Packs) : Camera & Photo
Amazon.com : PCTC Tempered Glass Screen Protectors Film Compatible for Fujifilm Fuji X-T200 XT200 X-A7 XA7 Protective Cover (3 Packs) : Camera & Photo
www.amazon.com
As stated, they come in a 3 pack for $7 and with Prime shipping, arrive in one day. I got them yesterday and did the first install this morning. Here are photos with the glass laying on the screen for sizing and positioning, and then after applying it to my screen.
Checking coverage & position
After application
It was very easy to apply, I cleaned the screen, peeled off the back cover and used my thumbnail at the bottom of the screen for the top to bottom position. There was no need to press out any bubbles, none appeared. I just started pressing upward from the bottom middle and it stuck perfectly.
Amazon.com : PCTC Tempered Glass Screen Protectors Film Compatible for Fujifilm Fuji X-T200 XT200 X-A7 XA7 Protective Cover (3 Packs) : Camera & Photo
Amazon.com : PCTC Tempered Glass Screen Protectors Film Compatible for Fujifilm Fuji X-T200 XT200 X-A7 XA7 Protective Cover (3 Packs) : Camera & Photo
www.amazon.com
As stated, they come in a 3 pack for $7 and with Prime shipping, arrive in one day. I got them yesterday and did the first install this morning. Here are photos with the glass laying on the screen for sizing and positioning, and then after applying it to my screen.
Checking coverage & position
After application
It was very easy to apply, I cleaned the screen, peeled off the back cover and used my thumbnail at the bottom of the screen for the top to bottom position. There was no need to press out any bubbles, none appeared. I just started pressing upward from the bottom middle and it stuck perfectly.
