Battery Extender Holder

mmwada

Member
I can never find a good place to store the battery extender. It normally rolls out of place or takes up more space than I want it to. I cut a 3.5 inch PVC pipe to fit and used a cut piece for the bottom to keep it from sliding through. If you never (or even if you did) cut PVC pipe before with a power tool I would stress using a non electric tool. I know this is an electric bike forum. Cutting plastic and wood are completely different materials. Wood is forgiving, plastic isn't.

Screenshot 2023-10-04 at 10.11.36 AM.png


Screenshot 2023-10-04 at 10.12.08 AM.png


Screenshot 2023-10-04 at 10.12.30 AM.png
 
Very clever.

I'll just add the thought that I doubt the RE would mind being stored upside down, saving the effort of threading the cable through the holder.
 
Very clever.

I'll just add the thought that I doubt the RE would mind being stored upside down, saving the effort of threading the cable through the holder.
Thanks for the comments. The connector going into the battery protrudes too much preventing sliding the battery in upside down. The tolerance is too close with the PVC pipe.
 

Attachments

  • Screenshot 2023-10-08 at 11.45.47 AM.png
    Screenshot 2023-10-08 at 11.45.47 AM.png
    794.6 KB · Views: 59
Back