36v hall effect voltage same as 48 v hall effect?

[tomjasz]

Try these instructions by Spinningmagnets. It is not a video, but he has pictures.

https://endless-sphere.com/forums/viewtopic.php?f=16&t=51310

The MAC motors have been upgraded. Sadly that's the 2013 thread.

 

[tomjasz]

I'm trying to get my Mac12t apart

 

[indianajo]

Got the tamper proof screws off the bafang 500 w motor with a 1/32" die grinder wheel to cut a slot, and a DAF center punch to start them left. Then flat blade screwdriver.
Bafang stator is in a pot. Pulled cover stator & shaft. Can see the hall effect wires, note colors, cut Julet connector off and put .157" bullet connector on phase wires & white 6 hole block on +5, G, 3 hall effect pickups.
Don't have a puller big enough for Mac cover now. Lost $45000 tools+electronics 9/14/20. Six pullers went to fence. Replacing one tool at a time.

 

[tomjasz]

Got the tamper proof screws off the bafang 500 w motor with a 1/32" die grinder wheel to cut a slot, and a DAF center punch to start them left. Then flat blade screwdriver.
Bafang stator is in a pot. Pulled cover stator & shaft. Can see the hall effect wires, note colors, cut Julet connector off and put .157" bullet connector on phase wires & white 6 hole block on +5, G, 3 hall effect pickups.
Don't have a puller big enough for Mac cover now. Lost $45000 tools+electronics 9/14/20. Six pullers went to fence. Replacing one tool at a time.

Why not get the right driver tip? $6-$20

I’ve only used 3 or four but as they’re become more common I like having proper drivers.