Search results

I am old enough to have voted against Tricky DIck, but I can still do the left foot on pedal while swinging over the seat. Height of pedal depends on whether it's my cadence or T/S bike, Reversing that to dismount can be problematic, Foot gets hung up on luggage rack or those baggy cargo...

The bike must work otherwise. A Google search for HJM+set password shows you having this problem in July, 2024 in another forum. Are you sure you are following the right procedure to enter a password into the display? Some displays I've owned come with a default password (many bafang displays...

That is awful sad news. My condolences to Matt's family,

Yes. The Fazua, as I read it, puts out 1.9N at its output shaft, and that motor is much longer than a 135 mm dropout on a typical bike. It multiplies that with a gear that turns the pedal axles, with further increases thru the derailleur. Your concept drawing show a motor not much wider in...

Your display will only work with an aostimotpr controller, so both would have to be replaced if you go third party. Any replacement will require moving the old motor cable to the new controller. The throttle, brake levers, and pedal sensor connectors may have to be worked on too, In general...

Hope you succeed, . Seems like you'll be using a lot of gears in there to push a bike..

Six years ago, I found my wife's "Herman's Hermits Greatest Hits" album cover and Peter Noone signed it after a concert. He was amazed that it was an original over 50 years old and not a reprint.

In BMS terminology, C- and P- are the negative terminals of the charge and discharge plugs. B- is the negative end of all the cells, The voltage from B- to either one is very low, almost zero if the BMS is working. You're not getting any voltage across the output pins? Check your 20 cell...

Have you ridden the Silver Comet? I've haven't, but it has a great reputation outside of Georgia,

EBR reviews on tjhis website say the Smart-Motion Pacer ebike has both torque and cadence sensors. Your display says the cadence sensor isn't working. I would look around the rear derailleur for an electrical cable going to some kind of combo torque/cadence sensor and check its connector...

I appreciate your problem. That's a connector I've not seen in the over two dozen controller's I spent money on, Still, even if you find one with the proper plug-in-play connector, odds are it will not work with your aostirmotor display, What was the issue with ordering from aostimotor's site...

You might want to show a pic of the other end of the motor connector. Worst case, you buy another 25A controller and move the motor cable from the old unit to the new one, making the splices inside the controller box. Wire colors should match, but that's a guess on my part, Changing the...

Usually between $4 and $5 (USD) for a dozen, but I bought some for $1.99 last week, with the condition that I had to spend at least $20. Picked up a cut of beef, some italian sausage, and italian rolls. Chicago combos! Still haven't opened the eggs. Egg scarcity is due to bird flu. There is...

Did you contact HJM for their take on this issue? If it's a 4 digit password, there was one guy on this forum who just brute forced it. Started at 0000 and walked it up til it unlocked. Luckily, he set it for something in the 1200 range.

The last time I blew a battery fuse, I found Ace hardware had a good variety of round fuses sold out of drawers in their hardware section. Instead of $8.95 for two fuses in a blister pack, you could get one for under a dollar.

And I believe that was when a good camera was about one percent of your salary. if you had a good job, more if you were hourly. First job out of college paid $915/month. Spent my first paycheck on a lower end SLR camera. Paid around $120. I recall you could buy Exaktas from East Germany for $69...

The terror of bike paths is the walker with earphones. You know they can't hear your bell, voice, or even the roar of the knobby tires if you;re riding on them. You just hope they don't suddenly turn around as you pass. There;s a character by me that tows a small trailer with a big speaker...

Nice! Let's hope Greenbike can ship it to you in Canada. I believe that if I tried to get it to the USA, it's a flat rate $40 tariff on all small packages now.

I've used Olympus cameras since 1967. Have my working OM1 from the mid 70's. Also a Pentax K1000, but it's all digital for past 22 years. I went with micro 43 in 2010. Small mirrorless bodies. Just a amateur/enthusiast. I will usually carry one of my older m43 bodies with a lens, Packed in a...

Is this a front hub motor?