Search results

I guess it would not hurt to do that again. Thanks

Internal

I have a Bam Nomad which is same as Rad Rover 5. Has SW900 display. Will not show speed or odometer. Occasionally throws error 24 but power off and back on clears. Could it be sttings? Does anybody know factory default? Any other ideas. Thanks in advanced.

I am looking for 4 in 1 wire harness for either a Bam Ebike or would try Rad Ebike. Or maybe someone knows where I could get controller, wire harness, throttle and display that would work together. Motor connection on controller would have to be 3 main pins surrounded by the other 5.

Does anybody know wiring for Bam Ebike wiring. I have 10 wires from controller of various colors. 5 go to the display, 2 to headlight, and 3 to throttle. How do I know which is which.

Not green ... gray. Two should be for headlight.

I have exposed all wires from wiring harness. The throttle has red, white, and black. I have tried all combinations with white, orange, and brown .... nothing. If I touch purple and green, the motor goes on without throttle. Any ideas?

Yes....

Yeah.... I'm blind as a bat. I never noticed the wires around the outside. Do you know what that kind of plug is called?

Or maybe somebody knows of a wire harness that will pull the 3 pin motor, KT controller and KT LCD3 display all together.

Actually looking to start over. Keep same motor and battery and find a new controller, new wire harness, new display, that are all compatible. The only way I think I can get it to work.

No... connection to motor has only 3 pins.

Reopening this thread. Could not get this to work. Want to kind of start from scratch. Bafang 750watt rear motor is good, 48v battery is good. Suggestions for new controller, wiring harness, and display that will all work together with current motor with 3 pin connector, and throttle and PAS...

Listed on Ebay .... buy without worry.

I have two 35amp controllers with KT LCD3 bought from Electro Bike World and never used. Power cord from controller to battery will have to be spliced on. Display on 1 is 5 bare wires and Rad connector on the other. Could not get to work on my Bam Nomad. Each kit, controller and display $110.00...

Yeah.. Did change both display and controller. KT LCD3 and KT 35 amp controller. But no luck.

I messed up wiring harness. Waiting for a new one. Thanks for all the help. Will get after it with new harness. Whenever it gets here

I just checked my throttle. Black to white 4.47v, Red to Black about .5 and white to red about .5

Will double check. Could be throttle and peddle assist is wired differently. I cannot think it could be anything else except brake cutoff. When my son gets here going to bite the bullet and cut throttle cable to test. If that works then I will try peddle assist. If that does not work I have no...