Gionnirocket's latest activity
-
Gionnirocket replied to the thread I finally took my ebike for a test ride..Just shut off the display. Don't think anything bad would happen... But while I'm connected to the Y cable, I always leave the display... -
Gionnirocket replied to the thread I finally took my ebike for a test ride..I've found that the easiest way to disable pedal assist is to not pedal 🙃 But setting the Start Degree to 20 as you have it is really...
-
Gionnirocket replied to the thread Rohloff e-14 oil leak.Yeah that's not what many complain about when talking about seal leaks. They're talking puddles on the floor. Be sure to drain as much...
-
Gionnirocket replied to the thread Rohloff e-14 oil leak.How many miles on the hub? Are you sure that it's the hub leaking... The stain looks dry in the photo. Honesty... I'd live with that...
-
Gionnirocket replied to the thread I finally took my ebike for a test ride..Just be careful crossing rail road tracks... You may get stuck to the rails with all those magnets 🙃
-
Yes, that works great for larger nuts in places where you can fit a wrench into. The tubing idea is for small nuts in much more...
-
Gionnirocket replied to the thread Show Us a Tool.I know a lady that used a strap_on... but it was nutless 🙃
-
Gionnirocket replied to the thread I finally took my ebike for a test ride..Here's a homework assignment if you haven't seen this yet... I agree with most of it...
-
-
One of the handiest (and cheapest) tools I own. It's just a short piece of silicone tubing: Very handy for starting small nuts in...
-
Gionnirocket replied to the thread Peddle Assist not working.Also... If the communication error 30 is caused by a bad 1T4 cable... that can explain why you can't connect your laptop as well
-
I do not have specific experience with this motor. On some you can clear the code by doing a reset and then go in through the display to...
-
Gionnirocket replied to the thread I finally took my ebike for a test ride..For how you want to ride I would try this.... Remove the Speed restriction on all the PAS settings by setting them all to 100% and only...
-
Gionnirocket replied to the thread Peddle Assist not working.You do not use the software to sync the motor with a new controller... You use a special display...
-
Gionnirocket replied to the thread Rohloff e-14 oil leak.Not sure if you saw the update... but sometimes leaks are attributed to using too much oil. Rohloff has decreased the amount of oil used...
-
Gionnirocket replied to the thread Archon X1 Programming Thread (questions and experiences).All of this is very interesting... and if I was younger I maybe would dabble just for the experience. But things being what they are...
