Wire mess

[Daymak duds]

Anyone label these.? It's what I was left with,first pic is a used controller

 

[AHicks]

No idea what you are working on, but to my knowledge, without a wiring diagram from the people that made or market that controller, you are pretty much dead in the water. I'd be pretty surprised if anyone were to identify all of those wires with any accururacy.

 

[Daymak duds]

I actually have power to motor , that's the easy part. Now I think black, red with stripe and single red (electric power)switch go together for ignition, now throttle from bike is gr, red , black but different from controller, green with yellow stripe from controller go to single black (high brake). Oh well tomorrow's another day

 

[Daymak duds]

Anyone label these.? It's what I was left with,first pic is a used controller

Yeah I didnt even attempt it

 

[rich c]

Here's a tip, post this in DIY, Kits and Custom Builds and then say what controller that is, voltage, and what display and battery pack you are using. Also if you have motor interrupters on your brakes and if you have a built in headlight. That may provide a glimmer of hope of a response. It will take an incredibly talented builder to help you with that rat's nest. Not a lot of serious scratch builders on this site that I know of.

 

[tomjasz]

Post a picture of any label on your controller. It's likely you can find a wiring schematic, but need some search parameters. Purchased from?