Turbo Creo TCU Display Times-Out

[JimVG]

Hello,

New to this forum.

On my 2022 Turbo Creo SL Expert….when I turn the assist mode off (zero assist), after an undetermined amount of time the TCU screen times out and goes black.

Is there a method of either changing the time-out period, or ultimately setting the TCU screen to remain active?

Thanks!

 

[Te. S]

hope this helps you it should be in the display setting good luck

 

[JimVG]

hope this helps you it should be in the display setting good luck

Thank you for the reply! Unfortunately, this video does not demonstrate a function that will eliminate and/or change the TCU screen timing out after an undetermined amount of time in “0” mode (no assistance). There is no applicable setting under “Disply” settings or “Customize Display”. You suggestion is appreciated!

 

[kahn]

Hello,

New to this forum.

On my 2022 Turbo Creo SL Expert….when I turn the assist mode off (zero assist), after an undetermined amount of time the TCU screen times out and goes black.

Is there a method of either changing the time-out period, or ultimately setting the TCU screen to remain active?

Thanks!

Is it timing out or actually turning off? Does it instantly come back by a brief button tap or do you have to turn the bike back ON?

 

[JimVG]

Is it timing out or actually turning off? Does it instantly come back by a brief button tap or do you have to turn the bike back ON?

Thank you for the reply. I will check that and report back.