Steve Prehoda
New Member
I would like to use a humongous 28Ah triangle battery on a new Pedego Interceptor to be purchased in November. The discharge lead from the EM3ev battery is a XT90-S and the Pedego controller connector is a two pin male connector made by DAPU as shown. So, I need the female DAPU two pin connector on a tail piece to make the connection.
The Definitive Guide to Ebike Connectors at https://www.electricbike.com/ebike-connectors/ does not show what I need. Does anyone know where I can find these connectors?
Finally, if these cannot be found then I am thinking that connectors are connectors and any connector will do the job as long as it is waterproof and rated for the maximum voltage and amperes. So I could just swap out the DAPU connector for a XT90-S.
Please tell me if I am not correct.
The Definitive Guide to Ebike Connectors at https://www.electricbike.com/ebike-connectors/ does not show what I need. Does anyone know where I can find these connectors?
Finally, if these cannot be found then I am thinking that connectors are connectors and any connector will do the job as long as it is waterproof and rated for the maximum voltage and amperes. So I could just swap out the DAPU connector for a XT90-S.
Please tell me if I am not correct.
Attachments
Last edited:
