Bafang LCD C963 Modes - How to get PAS 0???

Alan2000

New Member
Have have 2 BBS02 kits I installed in my bike and my wife's bike. Both are Model SZZ9, Hardware Ver. 1.1, Firmware ver. 2.0.1.1, 36V, 25A units. One C963 has available PAS modes 0, 1, 2, 3. The other only has available modes 1, 2 and 3.

I like the mode 0 so the unit can be on yet provide no assist. I have a programming cable and I could do a work around by programming Mode 1 to have zero assist. But I'd like to figure out how to get mode 0 to display like with the other unit.

Appreciate any help. Thanks!
 
BTW - I have not seen any option to change the display modes using the USB programming cable for the BBS02. I can reprogram how each of the modes respond, but I don't see where to add or delete PAS modes with the software to program the BBS02.
 
Back