AxialFlux
Member
I was designing this before I found out about the magnetic cables, and think they might work better in my situation. However, someone may find this useful, so I uploaded it to Thingiverse.
www.thingiverse.com
Ebike Brake Cutoff Switch Holder by AxialFlux
Printing with no supports works fine, so long as it is printed face down. Note there are two files, the switch holder, and the block that activates it.This should work with the common ebike brake handle swicthes that come with most conversion kits, and can be used if your gear levers are...
www.thingiverse.com
