Search results

  1. Nelson37

    Wheel hubs and air vents/good idea?

    I live in Florida with a similar motor and they are just not necessary. Without combining them with Statorade or oil their effect is minimal. These are best for Direct Drive motors, and not for geared motors, as a general rule. If cooling is necessary during normal operation then you have...
  2. Nelson37

    compatible led display control

    A CA, and the time, effort, and energy to install and configure it, is likely worth more than the entire bike. That display provides a vaguely accurate voltage, NOT total power available, but ONLY voltage, meter, which can be replaced with something much, much better for $20. It also provides...
  3. Nelson37

    compatible led display control

    If I had some idea about what your kit was or where you bought it, that might help but since that appears to be an extremely common older display type, nearly identical to what I have now and what is on my spare kit, and I have seen them many, many times, my best guess is that you have spent no...
  4. Nelson37

    Crazy Stupid Commute

    What you want is definitely not normal, but not too hard to do. Whether or not you need suspension depends on the road conditions where you are. Loss of control rather than comfort is the real factor. Disk breaks virtually mandatory much over 20mph, hydraulic or not is an option. You will...
  5. Nelson37

    Is 1200w too much power for a front hub...

    I guess I should apologize to JRA for not using my crystal ball and understanding that what was given as a battery spec was actually a hard limit set thru unspecified hardware which allowed his equipment to perform strictly within those limits in a way that other similar motor kits absolutely do...
  6. Nelson37

    Is 1200w too much power for a front hub...

    Well, most of the people who have gone over Niagara Falls in a wooden barrel have actually lived, with only a few dead, but it is still an incredibly stupid idea. Also. 1200 watts is NOT repeat NOT "peak Power", it is peak SUSTAINED power, peaks will reach well over 2000 watts on such a motor...
  7. Nelson37

    Wheel hubs and air vents/good idea?

    keep us advised how it works out.
  8. Nelson37

    Wheel hubs and air vents/good idea?

    I am fairly familiar with how the Amish live. I've not known one who would back away from a job that needed doing. If a man can walk 5 miles north, then he can walk 5 miles south, east, or west. You got here. You bought a quarter horse when you needed a plow horse. You are right on the edge...
  9. Nelson37

    Wheel hubs and air vents/good idea?

    I just spent 30 seconds doing the research you should have done and verified that at least several, and most likely all, of those motors are Direct Drive, and therefore are good candidates for either screened vent holes with varnished coils, Statorade and Hubsinks, or partial light oil or ATF...
  10. Nelson37

    Wheel hubs and air vents/good idea?

    If those numbers are accurate then you have zero problem. Your earlier 33 mph number must have involved a downhill or extreme pedaling situation, which means it was not useful info and in fact, caused incorrect analysis and therefore should not have been posted without full explanation. A...
  11. Nelson37

    I Am Buying An Electric Bike...

    I hope it was clear that I was making a very sharp contrast between the dealer I mentioned, about whom virtually any knowledgeable person would say exactly the same thing, and the dealer you mentioned, about whom they would most certainly not. There are several reputable, honest, quality...
  12. Nelson37

    I Am Buying An Electric Bike...

    Gator, there are other Vendors you should check out. Highly recommend Paul at em3ev. You should work with a dealer who is honest and reliable.
  13. Nelson37

    Wheel hubs and air vents/good idea?

    First, that's not hot at all, BUT, the windings inside are a LOT hotter than the outer shell. You really need an internal temperature sensor to have a good idea what is going on inside. Around 180F and above is when bad things start happening. What is your speed on the hill, and what is top...
  14. Nelson37

    Wheel hubs and air vents/good idea?

    That would indicate geared and not direct drive. The gears are internal to the motor, basically a small direct drive with a set of gears around it. Definitely make no holes. Statorade much less feasable. Light oil fill, or ATF, and/or, heatsinks. Hubsinks (TM) are available for several...
  15. Nelson37

    Less than full PSI on tires?

    Tried cheap tubes for a while. No more, go to the LBS and get a quality tube, always, worth it no question. On the PSI, it's kinda like asking how much ketchup to put on your fries, try it and see how it works for you. Softer ride vs more resistance and maybe slightly more flats. At your size...
  16. Nelson37

    Wheel hubs and air vents/good idea?

    First, it depends on whether or not you have overheating problems NOW, and also whether or not your hub is geared, or direct drive. I was quite surprised to learn that water inside the hub is not really a problem, unless huge quantities. Waterborne grit and rocks and such are issues, most put...
  17. Nelson37

    Read it all and still clueless

    A mid-drive will involve a lot of shifting, for the hill and for any stops. It will not be like the electric motorcycle you really want. But, a mid-drive is the only type of turn-key ebike that is still a bicycle, will do 28 mph if you get the right model, and climb that hill with zero...
  18. Nelson37

    I Am Buying An Electric Bike...

    3 and one-half years, 12,000 miles, daily use, only vehicle, Zero problems other than the one late night where for some reason the bike refused to go thru the door sideways. i chose my motor because mileage reports like this for my model are fairly common. Other models in the same class, not...
  19. Nelson37

    I Am Buying An Electric Bike...

    Personally, IMO the selection of standard bicycles is dramatically greater, and a motor/battery kit can be selected to meet your need, with easy installation. Riding all year will vary dramatically in its requirements depending on where you are, like Alaska or Florida. The challenging hills...
  20. Nelson37

    Is a Specialized Turbo Vado overkill for an older guy?

    The last car my mother ever owned was a Corvette. She actually did not like it much, but she did enjoy owning a Corvette. The last car my grandfather owned was a deluxe model with all the bells and whistles. He put less than 500 miles on it, but I was told he did enjoy just sitting in it...
Back