Search results

No, just wanted to know if the motor or Kiox rolls over at 10 Gigameters. But it just stops counting at 4 Gm which equals 4,000,000 km

@FS27 Just create your own screen layout. Like this for example

I told Bosch the last time 5 years ago or so about this miles/kilometers thing. I just ignore it. However, I use my Nyon since 2014 and they fixed a lot of bugs in the first years. But this one seems to be pretty hard to fix 🤭 All the nice features including the big screen weigh more than this...

@TrevorB It is not only a matter of the bolt pattern. Also the chain stays. If they are too low, they are in the way of the chain.

Not this one, but I also have Gen3 in a different post https://electricbikereview.com/forums/threads/new-bosch-performance-line-gen3-bdu-385p-65nm.52079/

Anyone interested in a new Bosch Gen3 with 65Nm? Would be a nice upgrade from a Gen3 Active Line with only 40Nm or 50Nm. Brand new, MY2020. eMTB mode possible. For configuration questions, just send me a PM. $450 plus shipping.

A 2014 motor does not support dual battery. No more information required. I will send you a PN

December 2014. <MY2017 No dual battery. Here is how I do it on one of my bikes: @pavjayt if you want a sweet upgrade, I have some new Generation 2 Performance Line CX motors. The latest hardware (MY20) with eMTB, 75Nm, 6V or 12V light, even eShift possible...

If the drive unit is <MY2017, it will not work. Only on drive units MY2017 and later. And the batteries of course need a software version from 2017 or later. What are the first 3 digits of your drive unit serial number? This will tell you the date when manufactured.

Yes. That is unusual, but happens. There are a few small businesses in Germany / EU that actually replace all bearings if needed. A complete makeover is a little over 200€, which is very reasonable. Would be like $1200 in the US 💸💸💸

That is awesome, but Bosch is really good when it comes to warranty even after 2 years. If the motor was too old, there is a service kit that includes the right side motor cover with the main bearings and gears that usually go bad in wet conditions. It is only just over $100. I just fixed two...

Why in the world... Remove the old one and put a new one in. It could also be the balancer chip, but that would be a little harder to replace

Correct. Yes

They should have built them with two motors 😁

The Gen4 does not fit on your Tandem. But yes, that would be some improvement with more torque.

@rich c Just read it right. The latest ones FOR the small sprocket. There were several different versions for the small sprocket. <MY17 without walk assist etc and so on That's why I added all the information like Gen2 and 2014 - 2018 That motor actually is a MY20 (still Gen2), which means it...

I have some new Bosch Performance Line CX motors, zero miles. These are the latest ones for the small sprocket, MY20. Great as upgrade or replacement for any Performance Line or Active Line (2014-2018) that come with the small sprocket. They have all the features like Walk assist eMTB mode...

No need to build anything. Just turn it on and park the bike on the pedal. Means, use the pedal like a kickstand. You just need a brick or something to support the pedal. The permanent little torque on the crank will keep the system on until the battery is discharged. You should discharge it to...

You can pull the pins out with a needle to get the plug off. Then you don't need to drop the motor.

If your new bike uses horizontal 625 PowerTubes, I would trade you one in for the PowerPack batteries.