Recent content by Marcela

Exactly what I said.

What's your time worth? I find the older I get, the more valuable it is. :)

Anybody know what this stuff looks like? I opened a Hentech motor and it had some clear silicone looking grease with what looked like graphite mixed in. Wonder if it the Bosch stuff.

Been using the phone and switched to this timer. Works perfect. And works with the two battery bikes with two chargers. https://www.menards.com/main/electrical/light-switches-dimmers-outlets/outlet-timers/mytouchsmart-simple-set-2-outlet-outdoor-digital-timer/26898-p2/p-177023396724132-c-6471.htm

It is like rubber cement. I used shoe goo to repair a hole in a rubber snow boot about 35 years ago and it is still there. On rubber cement, it is all similar, labeled for different things. I found some that was recommended for crafts, said it was dryer and washer proof, so using it on some...

Shoe Goo is pretty good stuff for repairs.

Skateboard shoes would be good.

Replaced the freewheel with something I like. the oem has a jump from 1st to 2nd of 34 to 24, really there is no 2nd gear which I need as I prefer torque pas. Think it is sunrace has one that is 34,28,24. removes the top gear of 11 teeth and 13 is the top gear which is fine by me. I am much...

Here is my contraption. Made it a while back and made some mods to it to lift the 140 and 160# Wired bikes. Usually I take one or both of the 20# batteries out to balance the bike as I lift from the upper cross bar. It is a harbor freight 4 wheeler lift with the front cross removed that...

Time change is about control. Getting rid of the time change would give the sheople more freedom, can't do that.

My wired ebike chargers put out 3.5 amps and have a fan.

I looked at the Globe and Aventon side by side, that Aventon looked pretty good. Both looked good though.

One of them is gonna work.

Just ordered one of the freewheel removal tools from Area 13 for the dnp freewheel. Hope it fits over the M16 axle and into the splines for the Wired ebike.

Wired is sending a bottom bracket and both controllers in an effort to remedy lack of torque mode pedal assist. It takes way too much effort in torque mode to get the pas work. I have to stand up and pedal to get assist, then can sit down while continuing to pedal and it will work. Once I...