Recent content by JakeV

Yes, I have settings for "PAS Levels". I currently have a 0-5 and I can also set it to 0-9 amongst others. So I guess it is all about setting the PAS Level at the highest to have most granularity on the display and Proration setting at the maximum 100%. Thanks again

Yeah, this is what I was asking myself. I will give it a try, maybe tomorrow. We are having pretty nasty weather, freezing rain and high winds today and possibly tomorrow. I did notice though that 50% in the snow was a very good ratio. Thanks for the tip and the info, much appreciated.

So here is the lastest on the K5351 TFT controller/display For one, there is no word "Proporation" in the english language. This appears to be some kind of bad translation error, a contraction betwen Proration and Proportion. From my readings, the K5351 TFT controller/display is designed to...

Thanks for your reply it is much appreciated. Unfortunately this setting does not say a lot and I beleive I will need to experiment a little on my own. Of what I understand you probably either use Torque setting or PAS setting but not both. Torque setting is used to mimick a normal bike use...

Hi I just bought a new MAUI e-bike and I was wondering if any one has experience with the K5351 TFT controller? Unfortunately setting instructions for "PAS level select setting" and "PAS ratio setting" cannot be set while the unit is in "torque mode". Bummer, no where does it say how to get...

I wanted to convert my DAS-KIT X15 motor from a freewheel to a cassette but I fell into some issues so I am sharing this for anyone who would like to give it a try and find out if anyone has some input on persuing the task seeing this was already discussed here. Capture 1 - Shows the DAS-KIT...

I experienced a similar issue last week where the pedal assist just stopped working. Usually my bike sleeps outdoors even in winter and I had never experienced this kind of malfunction in earlier years. I took the bike indoors, cleaned the sensor and voilà, everything works just fine now...

The lock is actually a no twist or anti twist lock which means even if you mamage to make one cut through the U bolt you will not be able to open or twist the 2 parts apart enough to release the bike from where it is anchored. You will need a second cut on one of the 2 very unstable parts now to...

So yesterday, I went dowtown Montreal for a quick 25-30 minutes hearcut. This was done with a hand saw, in broad daylight, in a park facing a community Police Station. The nerve of those people. Well, it's a bummer to have to buy a new lock but hey! I still have my ebike.;) A good lock is a...

Hi all, Anyone ever went through the process of greasing the front fork/suspension on the Milano? I have a Suntour 28 but there are no greasing hole. I found this video but it lokks like an overkill to grease the fork.

You probably can change model but I would start looking onto Shimano's site to see if there are equivalents to your own model. Possibly a higher quality product/model. You can write them and ask.

Hi Sandro, A loose crank is definitely an issue that needs to be fixed. I am not familiar with the pas sensor but it most likely magnetic and it makes sense that it would be affected by a loose crank. Tolerance is probably in millimeters. I've not read all your post but to isolate the problem...

Hi thanks for both your replies, I beleive both of you are right. I took a second look and I could not see any notches inside the gears assembly so I went in with a small screwdriver and voilà I can definetly feel the notches inside. I then took my very powerful bike light and I can see what I...

Hi, The actual inside width is 2.5mm compared to 1.9mm for the original.