FrankPoz
New Member
- Region
- Europe
- City
- Padova
Greetings to everyone.
Perhaps this problem has already been dealt with and I apologize if I propose it again but reading the replies it is not clear to me.
I had an E010 error.
I saw that there are some posts on the subject but I apologize I don't understand the solution well.
The error occurred when the engine was started. I was pedaling but as I usually do, I don't put pressure on the pedals. In any case, even when stationary and with horizontal pedals, the error appeared. I waited a few minutes and removed and re-installed the battery. mine is a BMC AMP AlpenChallenge Sport. I finished the tour with no more problems. Reading the posts it seems that this type of error depends on the torque sensor or on a bad connection between battery and engine or on the engine connectors. I have never taken the water with the bike and every time I charge the battery but without removing it. Could it have been the vibrations that made the battery and battery holder unstable? thank you
Perhaps this problem has already been dealt with and I apologize if I propose it again but reading the replies it is not clear to me.
I had an E010 error.
I saw that there are some posts on the subject but I apologize I don't understand the solution well.
The error occurred when the engine was started. I was pedaling but as I usually do, I don't put pressure on the pedals. In any case, even when stationary and with horizontal pedals, the error appeared. I waited a few minutes and removed and re-installed the battery. mine is a BMC AMP AlpenChallenge Sport. I finished the tour with no more problems. Reading the posts it seems that this type of error depends on the torque sensor or on a bad connection between battery and engine or on the engine connectors. I have never taken the water with the bike and every time I charge the battery but without removing it. Could it have been the vibrations that made the battery and battery holder unstable? thank you
