Lectric XP 3.0 step through handle bar diameter @ clamp and stem.

[Santa]

I don’t have the bike yet. But would like to know-Are the handle bars 1-1/8” or 1-1/4” diameter in center where the clamp goes. Also what is the diameter of the stem. Thinking of an adjustable neck, want to get the correct one. Thanks for your replies.

 

[sc00ter]

I don't fully understand you're question but these are the leftovers from my BMX bars conversion, thread below in the same section you posted.

 

[sc00ter]

Your XP 3.0 will have the height adjustable stem like my 3.0 had. The picture I posted shows it beyond max. Give me a second......

 

[sc00ter]

Hope this helps.

 

[sc00ter]

That approximately 1.25 on the cheap Centec calipers is in inches.

 

[Santa]

Thanks for the replies. So the bar center diameter is 1.250” (1-1/4”). Great. I still need to know the diameter of the stem/ post itself as clamps come is various sizes. Thanks

 

[Santa]

Wait… I think I spotted 28.6 mm (1-1/8”) printed on the stem/post at the bottom . The post that sc00ter posted. Thanks

 

[sc00ter]

If you need anymore pictures or measurements just ask. I forgot to swap over to centimeters.