Hi,
I'm wondering if anyone has pulled the circuit board out of a KT 22A controller and could tell me what the dimensions are. I have the outer dimensions of it in its aluminum case, but the hole I need to put it in is a bit smaller. Being a dufus, I went ahead and ordered it with the assumption it will fit, and that I could pot it into a smaller form factor. The hole (frame) I need to fit into is 1 1/2" x 2 1/8" x 4".
Sorry in advance if this is considered cross-posting. I have a more general discussion about my project running in the Aventon Forum here: https://electricbikereview.com/forums/threads/kt-controller-display-on-a-pace-500.43619/ but I wanted to ask this question to a more general audience since it revolves around a non-Aventon controller.
I'm wondering if anyone has pulled the circuit board out of a KT 22A controller and could tell me what the dimensions are. I have the outer dimensions of it in its aluminum case, but the hole I need to put it in is a bit smaller. Being a dufus, I went ahead and ordered it with the assumption it will fit, and that I could pot it into a smaller form factor. The hole (frame) I need to fit into is 1 1/2" x 2 1/8" x 4".
Sorry in advance if this is considered cross-posting. I have a more general discussion about my project running in the Aventon Forum here: https://electricbikereview.com/forums/threads/kt-controller-display-on-a-pace-500.43619/ but I wanted to ask this question to a more general audience since it revolves around a non-Aventon controller.
