Boscj gen 2 motor

[Noobie]

Hi, I just changed the bearings on my engine. However, the engine does not work when the pedals are turned, the engine does not start. However, the display and speedometer work and there are no error codes The walking mode was broken before, so it doesn't work now anyway. I dont know why, maybe the buttons are broken What could be wrong that the motor not start? Thank you!

 

[wildtrak]

Are you just turning the pedals or are you actually trying to ride, means putting some torque on it?
How was the walk assist "broken"? It does not break, you can configure it to be disabled.
Did you put it in any assistance mode other than "OFF"?

 

[Noobie]

Are you just turning the pedals or are you actually trying to ride, means putting some torque on it?
How was the walk assist "broken"? It does not break, you can configure it to be disabled.
Did you put it in any assistance mode other than "OFF"?

The torque sensor was somehow badly tightened, now the motor work correctly. What do you mean about walk assist, how it will be disabled?

 

[wildtrak]

What do you mean about walk assist, how it will be disabled?

In the diagnostic software you can enable and disable it. And it only works if any assistance mode is selected, does not work in "OFF" mode.
Unless you have a US version motor <MY17, they don't have walk assist.

 

[Noobie]

In the diagnostic software you can enable and disable it. And it only works if any assistance mode is selected, does not work in "OFF" mode.
Unless you have a US version motor <MY17, they don't have walk assist.

I don’t have that diagnostic software. So I don't think it would be possible for the walking assist to be turned off there.

 

[wildtrak]

I don’t have that diagnostic software.

Your dealer has. They can check.