I have an ecotric seagull 1000 watt, normal width wheel bike and had a flat on the back tire. Long story short. I took the wheel off fixed the flat and didn’t pay attention to the hardware/spacer configuration. Now, I can’t get wheel back on correctly either runs on the disk brake, or the derailer on the hub. Even my bike shop can’t figure it out. I have 2 claws, 2 thin spacers and 1 thick spacer. Can someone post a pic of the configuration? I can’t believe the manual doesn’t show the back tire assembly…reached out to the company and I keep getting cryptic messages…if you are in Monterey ca, I’ll buy you a beer if you help me out!!!
Back tire, spacer configuration seagull..help!
- Thread starter Chris bo
- Start date
J.R.
Member Since 2014
- Region
- USA
I can't directly respond to your particular bike. Your bike shop likely has limited experience with ebikes. When you say 'claw', I suspect you are referring to torque washers, but I'm not sure without pictures of everything involved. On this forum you have access to a great many of owners with years of experience. I suspect this setup is not extraordinary and someone will know the order of install. Post some detailed pictures if you can.
Pictures: all hardware, axle, bike dropouts, etc...
Best of luck!
One style of torque washer:
Similar threads
