Using the BionX CAN bus & technical info related

[cybercowboy]

Ha! Latecomer to Bionx here!

Can someone fast track me (a 61 year old ex- software and systems engineer) on how
to do tech level system work on the Bionx system using the CAN Bus interface, please?
Just getting me pointed in the right direction will be great.
Is there a manual? Is there an aftermarket write-up?

I have bought a CAN bus system for maintaining my Yuba eMundo bike.
I have not hooked it up yet not wanting to glitch the system...
My first job is to replace the G2 controller with a better spare. It appear to not
accept this unit- as if I mount it, it responds until I hit the + button, then it shuts down.
Its condition is unknown, so it is possible it is broken. But I'm assuming I have pair the
new G2 with the system (A security feature that you can't steel a bike minus the controller and
buy a replacement on ebay?)
Later I have new motor to install as if the current original motor- when asked for max
acceleration- something grabs inside and makes a lot of noise.
I figure it is wobbling and when torqued the magnets are hitting the case.

Thanks in advance for help!

 

[cybercowboy]

Just read this, sounded like my situation exactly. It IS my situation. I wrote this and got no response... *sigh*

 

[JRA]

This may be an avenue you have already tried but this company is probably the best bet for parts supply and tech info left for the BionX brand? https://www.bx-legacy.com/pages/technical-support-information

Otherwise you could post on the Endless Sphere eBike forum as there were some people there that had experience with the systems.