Search results

Hi Everyone. I am looking to sell my Gravity Blade 8 inch wheel electric stand up scooter as I upgraded. I want to sell it in working condition. Original battery was discarded ( no info on it) Problem is that the battery compartment is a sealed steel channel (pics below) My measurement of...

Hi Samsonboxer, I did not get it working, but it isnt the motor.

Hello ...I bought a Hyper Skute scooter 37v 350 watt. Scooter did not power on and no display. I was told it just needed a new battery. I got a new battery and replaced the controller as well. Now when I press the power button still no display but I hear a short tune and 1 beep, but black...

HI Harry , thank you ever so much for helping me through this ... its been a learning experience for me :) I will follow up 👍

Harry is it possible that my motor is bad? and if so how do I test that ? thanks Harry

There is no 6 pin plug , the old throttle had a display screen .

Hi Harry , pic attatched of the 3 yellow, white and brown, wires from old throttle -I don't know what they are for?

HI Harry yes it had a key ignition and I believe the brown & white {last pic) wire connected to the old ignition tumbler( I could not turn on -no key and battery was dead . I bought it knowing it needed a new battery and throttle with key . Here is a pic ( of what was left after I took it off...

Hi Indiana Joe, thanks ever so much ... very informative reply .I am attaching a pic of the controller and a red/black wire that is the only wire not connected to anything and my throttle wiring. there are a couple of red/black set of wires. I need the power up, power lock wire.:) Thanks

Hi Harry, I am replacing a damaged old half twist throttle with new universal throttle key ignition...that is all. controller, wiring, motor are stock. This is a DYU D1 (like Jetson but no PAS)Bike wasn't running when I bought it. I just would like to know where the colored wires ( the thin...

Hi HarryS I have voltage out from controller (36 volt) to battery connection, and 4-5v from throttle wires. The rear wheel moves freely going clockwise and also going counterclockwise with battery disconnected, I could not find any brake wires (black and white wires) to disconnect., there is a 3...

Hi Harry S. thank you for your reply:) I am attaching the pics The DYU looks like the Jetson Bike. Also Harry , can you have a look at this video by Vaueco This is what I was concerned about ( if you don't want to all start at 9:30 into video and you will see what I mean and why I am...

I am installing a new universal throttle with key on a recently purchased used Dyu D1(Gyroor C6) 36 volt 350 watt . This is a learning project.It did not run when I bought it , seller said needed a battery. I have a battery that i can use that is 36 volts. How would I go about attaching the...