Search results

I got mine in September. I've slowly been increasing the lengths of my rides. Friday I rode 15 miles which is my farthest so far. About half of it was in PAS 3 level. Some full throttle on one long straightaway. At the end I had one bar of power left. Though I didn't let it set for a bit and...

Did you hear anything yet?

You did a great job, the bike looks very clean.

Check out this battery, I think it would be an easy change (Link Removed - No Longer Exists)

I went with the more powerful battery, I like that it mounted on the rear plus it has a usable rack as well.

I bought the rear battery mounted 500 watt kit in August. I installed it on my little used late 90s Schwinn Cruiser Supreme. I did call the company twice for help and in a very few minutes each time they were able to help me out. It's really peppy, with the battery in the back and drive wheel in...

I would say your best bet on this is to go to the radrover website and use the contact option. They'll most likely email you back in a few hours, same day if you email them early enough. Or you could call them. They would know the best way to proceed. Grats on your bikes.

So my spokes are good to go. I should know better at my age to wear reading glasses so I make sure I use the right size wrench to tighten the spokes. The 3 loose spokes on the front were not stripped after all. I found one loose spoke on the rear, all are tightened now and I checked all the...

I have 3 spokes on the front wheel of my new Radrover that are loose and will not tighten? Are they stripped? Too long? Are they a standard size I can order online? Thanks in advance.

I got mine on the 21st of Sept. I ordered the black one.

Here is a photo of how I mounted my rear fender to the Radrover rear rack. I removed the arm that is used to hold the fender to the seat stem. I also loosened the bolts on the rear rack including the adjustment bolts shown in the photo and pulled the rack forward as much as I could, this raised...

Thanks for your reply, I'll try to see how much slack I can get. I may have to take it into the local bike shop if it proves too much for me to do but I'll try it first.

Hi, I'd like to raise my handlebars up, my neck has some issues and my hands start going numb with the current setup after a few miles. What size and brand stem did you use on your conversion? Thanks, Mark

Can I adjust the stem up on my Radrover?

That's exactly what I did with my new radrover I got on the 21st of Sept. It worked well. The fenders you get are longer than the fenders in the photo on the Radrover website.