Search results

Torque sensor on Bolton (KT) controller is not going to happen in any meaningful way.

Not sure where to find. Have you asked Lishui directly?

DP-2170-5C (125mm) is not as tall as DP9 (141mm). In many frames the DP9 is just a little too high to fit. DP-2170-5C is more comparable in size with G80.

Should work fine. Phase/hall sensor wiring order of course can always need adjusting (connector PIN order).

Yes. Lishui is ok.

Thats the faster one. You can verify by no load speed test.

Not sure if there are some other versions available but these two Wheels know. 06 is faster and 6.5 is bit slower winded.

Jumbo Shark need just little more room so yes fender needs to be modified. Sorry forgot to mention the reflector/rear light. If you dont have rear rack then spacer bracket etc are needed for that as well. The bike will fold.

Jumbo Shark "fits" but: - Rear fender needs to be modded a little. - Stock rear rack front mounting needs to be modded a little or otherwise the battery won't have space to side out.

Yes. Individual cable extensions is the easiest way. 10 PIN (5 to 1) main harness (or connector) is not not available in retail as far as I'm aware.

No actually I haven't watched that. Thats confusing I have to admit.

Maybe accidental but surely confusing.

Yeah. Bit confusing. I have asked and real specs are 60v absolute max volts ( so 52v battery max). Peak battery current 30A. I know some manufacturers like Kelly uses phase amps to rate their controllers...I believe same is true in this.

I know but apparrently the picture is not accurate in that sense. I have asked and got answer it isnt CR S107.

Its not CR S107 but something close I believe (I have asked about that).

Yes. Same as EBW & Bolton.

Yes I agree on that.

I like my KT based kit more. ~120 Peak phase amps 🙂

Yeah. I think 45A continous 80/90A amps refers to motor and L10 connector rating in phase amps.

Have you looked at 1000w Mxus xf19r? Its 140mm dropout. Motor connector is z916 (stock Rad).