spokewrench's latest activity
-
Sspokewrench replied to the thread What brake pads do I buy???.Several times since then I've heard a brief rattling like a piece of that wire picked up by a tire and hitting a fender. I circle and...
-
SI use resin pads too. I like them. I don’t use them much when I brake now though (thanks regen) so it’ll be a while before I need to...
-
Sspokewrench replied to the thread What brake pads do I buy???.Not long ago, I checked my rear brake because it sounded scratchy. I saw a fine wire sticking out of the caliper. It was something I'd...
-
-
SMatson have suspended EV shipping. A story worthy of the news, but supressed around most of the world. They need vastly increased fire...
-
Sspokewrench reacted to Slaphappygamer's post in the thread splicing Julet 4 pin tail light cable with
Like.
Nail clippers work well too. 😶🌫️ -
Sspokewrench replied to the thread What have you learned from your e-bike experiences?.“There was never a horse that couldn’t be rode, and never a cowboy that couldn’t be throwed.” I started riding English bikes in first...
-
Sspokewrench replied to the thread splicing Julet 4 pin tail light cable.I like the kind of LED headlamp with a voltage regulator, but the kind that runs directly off 3 AAA cells dims over a period of many...
-
SYeah, more s*it to worry about, right Spoke? My Star Union taillight takes a couple of AAs. It was stock with Fättie. It either...
-
Sspokewrench replied to the thread splicing Julet 4 pin tail light cable.It's disappointing to buy a 10oz caulking tube of stuff, use half an ounce, and later find the rest ruined. I've had better luck if I...
-
-
Sspokewrench reacted to Gionnirocket's post in the thread splicing Julet 4 pin tail light cable with Like.
My tip with most products like this is to not cut the applicator tip as instructed if it has a screw top and use a pin or small artist...
-
Sspokewrench replied to the thread splicing Julet 4 pin tail light cable.I tried that with my Radmission after I discovered that the tail light did not have a reflector lens. I figured in that case I should...
-
SOr, another option, spoke, is to cap/disconnect the wire and use a battery-powered (self) tail light instead. That’s (unfortunately)...
-
Sspokewrench replied to the thread splicing Julet 4 pin tail light cable.I'm sure they shorted when I mashed them under the center stand mounting. With the extension, I can see if the circuit still gets power...
-
Sspokewrench reacted to Slaphappygamer's post in the thread splicing Julet 4 pin tail light cable with Like.
Looks like you can remove the taillight from the rear rack. If you can, then remove it and move it closer to the controller and pull the...
-
Sspokewrench replied to the thread splicing Julet 4 pin tail light cable.In August, 2024 I ordered two 50ml bottles of "5210 Solder Multi-material repair adhesive Oil based glue." It turned out to be super...
