It was just a clearance bike off ebay I just want throttle working for when I sell it I want to find out if you can cut 8 pin julet off end and wire on a 4 pin is this possible
I brought a new thumb throttle with the blue 4 pin connection connected it to controller cable tried it before putting it on bike but nothing! Don't understand why its not working unless its because brake sensor cables are disconnected
I think the only option is i can get another thumb throttle which has a 4 pin connector and get an extension to controller as im selling the bike anyway I just wanted the throttle working
Hi my throttle wire harness snapped of right before sealed joint so couldn't repair it so im looking for a replacement wire harness which has the 2 red connectors for brakes and one yellow for throttle. The problem i have is the cable from control box for these is a blue 4 pin connector the only...
Hi my bike has given up now so I'm looking to get a new one been looking online at fat tyre ebikes with dual motors what are they like for road cycling i have attached pictures of 2 I've seen both have dual 1000watt motors and have good reviews and are priced at £1200 plus each?
As my pedal assist cable from the crank is only a male connector and the other end from controller is also male I done a rewire job by cutting female connector off original pedal assist cable and just twisted cables together it works but when I go to faster option it starts off fine then drops...
My dog bit the wire in half on my charger i twisted wires together and put electrical tape on it charges but takes ages to reach fully charged now when it used to be 3 to 4 hours and battery only lasts about 3 days is this damaging the battery or should I just get a new charger?