PedalUma's latest activity
-
-
-
-
PedalUma replied to the thread Clean Custom Conversions.I set my mid-drives to go into a 30% power limp mode until the internal temp goes under 100C. I do not know anyone who has done that...
-
The low available gearing with this bike, ~16 gear inches, makes up for lower power. I don't mind climbing slowly on steep hills, it...
-
PedalUma replied to the thread Just for fun....Sun screen is really good when cycling just make sure you reach for the correct one.
-
-
I always have theorized that it is a New York, New York thing. Long ago I had a client in NYC. Their primary way of interacting with...
-
PedalUma replied to the thread Clean Custom Conversions.Some cadence sensor bikes can be programed in about 20 ways. I make them start at 1 volt, without delay, or lag, and I take the overrun...
-
Yes controller is in motor. It is lower power compared to my mid drives TSDZ2 and Yamaha at 35nm but retaining the original drive train...
-
PedalUma replied to the thread Just for fun....I now know where D-ump got his negotiating style. He stole it from my ex.
-
-
Ya, tell that to my broken wrist! 🤨
-
-
PedalUma replied to the thread Clean Custom Conversions.@EMXG, Is the controller inside the motor. Very clean. Nice work.
-
Under "clean (and easy) conversions" I doubt if anything current comes close to Keyde hub motors. Simply swap in the wheel, single wire...
-
