juggernaut1's latest activity

The rating is relative to the other helmets submitted for testing. Your helmet is still 5 STAR rated, it‘s just that there are now 102...

Maxxis do a 27.5 x 2.00/3.00 tube which will obviously fit a 2.8 tyre which is OEM for the rear mullet setup on my Frey Beast. It’s not...

Looks a good package & low price. Powerful motor decent spec for price and full waterproofing. Prices are getting more sensible & with...

So an update on the Quiet_gear motor using Cornhead. @ 450mi total and 350mi since the initial Cornhead application the motor still had...

More DM01 updates DM01 vs BBSHD throttle compatibility As it turns out, I have a few spare BBSHD throttles which also use a hall sensor...

Just saw this timely post over on the EMTB forums with a member sharing their comparison of chains, SRAM XX1 chain compared to a couple...

I've been running X01 chains since before I first posted about them, so a few years. Two Luna Apollos, with 1500 watt output, bikes are...

I recommend reading this older thread on Mid-Drive Chain Care. The 80% wear figure your bike shop said you had was hopefully based on...

I have been looking at the X01 chains as a possible replacement, however I have seen posts where the hollow pins have been crushed on...

Several e-bike shops in Australia recommend the Mobil 28 grease. It has an NLGI of 1.5 per the data sheet, wide temp range with very low...

So we are currently in a very cold stretch here and I find no enjoyment in layering up to ride.... That and the MUP is a sheet of ice...

Welcome to A.I.! 😎

My strategy is based on what I hear when I shift and I have adapted the way I ride accordingly. To this end, upshifting into a taller...

Arguably one of the most reliable e-bike motors out there. Built like a tank with all steel gears, no nylon gears or belts here...

KMC e9 chain on Ananda powered hardtail ebike with shift cut - I only got circa 800klms before it was unrideable (badly slipping on...