Recent content by Joe W

I think that I jumped to the wrong conclusion that a threaded axle was the only option. After some searching, I found Corki Cycles12mm to 10mm QR Adapter Thru Axle Hub Quick Release 100/135/142/148mm Bicycle Front Wheel Hub Adapter. I'm not sure why it is designated as front wheel, and there...

Thanks for reply. I hadn't thought to look at other bikes (my landlord has a few left behind by previous tenant). Alas, none would work. One had a 7/16 inch axle, and another 10 mm. Some quick release ones that I haven't checked yet.

I have a Propella 9S Pro eBike. It has a rear hub motor. I want to switch to a Bafang mid motor, from a previous bike, as it has more torque and better battery life. The Propella has dropouts for a hub motor. The dropouts accept an axle that has flats on it. The axle diameter is 12 mm, and...

Well, the teamates at Bikesupportspecialist dotcom were wrong. It is left hand thread. They are sending a replacement lock ring because I probably damaged the original. Kudos to Mike there.

Wow, lot's of replies in a short time! An active group. :)

I want to get a definitive answer on the thread direction of the bottom bracket lock ring on the Tranz M16GTA motor. The bike is a Raleigh Sprite, 2018 model. Bikesupportspecialist dotcom (Alta Cycling Group LLC) tells me that a consensus of 6 teamates say it is "regular threaded", but they...

Hi, I'm Joe from Massachusetts, US. Years ago, I was given a broken Ford Thinkbike, which had been used by Leominster Police Department. I bought a generic controller and built and programmed a PIC microcontroller board to handle the throttle input, pedal torque sensor and brake cutoff. It...