It's a free hub. I went ahead and ordered the whole cassette because mine does have some rust in area's and the cost to replace all instead of just one gears isn't that much. Thanks for your input.
My new chain is slipping on the 11 tooth cog. It works fine on all other gears. It's all cleaned up and derailer adjusted. After looking closely at the cog it does look like the valleys on the cog are deeper and wider then the other gears and the teeth do look somewhat narrower. My question is...
Found my mistake, what a dummy. I used the female end of an extention cable to splice in and didn't take in consideration that the wiring would be just the opposite when the two cables are connected. 🙄
It's not the display. If you can reread my first post it explains the original problem. The bike was running before I spliced in the cable. Yes I contacted Lectric and also acouple others claiming to have controllers but none of them could help me. I am afraid I may end up with one of those 80lb...
That was my next thought. Like a dummy I didn't check the pin out on the thin HALL sensor wires but the 3 higher guage wires are the same as the stock cable. Will let you know the outcome.
I have a Juiced RCS with damaged cable from the controller to the motor. The bike would work but the display would lose connectivity. I repaired the cable soldering some broken wires. The display started working again for 2 months and then quit again. I purchased a 20 inch extension cable with...